Search the Community
Showing results for tags 'jeep cj3b'.
Hello fellow jeepers, I'm new to the forum and wanted to share my current project. I have an old flat fender that's been in the family for around 30 years that was in dire need of restoration. It's turned into a ground up, the frame was twisted and severed in the middle and the tub was all rusted out. I completely rebuilt the frame, straightened it all out and reinforced the weak areas. I didn't box the frame as I want to retain some flex. I did some extensive panel replacing and patching on the tub and built new floor pans for the front and rear. The axles are stock D44 rear and a custom buil
Ok, got my subscriber membership now. So, after not doing much with the jeep the past couple winters due to my snowbike hobby I jumped back in yesterday. I have to reassemble the front axle and clean the rear axle housing. I ran into trouble with the new front wheel studs that came with my new wheel bearing hubs. There is a shoulder behind the knurled section that would not allow proper press-on fit. The jeep parts vendor sold me the wrong studs it appears. Napa was able to look up studs for a scout and I was able to look at one to confirm it will work. A second problem I found was my ne