Search the Community
Showing results for tags 'egr valve'.
Found 2 results
I recently bought a 1990 Jeep YJ with 4 cyl 2.5 TBI engine. The jeep runs great except during warm-up. It starts fine and runs and idles well initially. As soon as the temperature gauge begins to climb off the 100 degree mark, the engine begins hunting and surging and usually stalls. If I push down on the accelerator and run it to 1000+ rpm, I can get the engine to heat up to operating temperature. At that point (~160-170F) the idle becomes stable again. So far I haven't done a lot of troubleshooting but have checked the EGR valve, changed rotor/cap, air filter, and fuel filter with no success. I'm wondering if it might be a bad O2 sensor that's slow to heat up which will be the next thing I check/replace. Any ideas or help is much appreciated!
I have purchased an 87 yj tbi 2.5. With help from this site I have been tinkering with this thing trying to get it to run as its suppose to especially in this cold weather. I was looking at my egr valve while I was replacing the vacuum lines and noticed it was unhooked and the line feeding it is plugged. I did notice that the vacuum port on the egr was facing the front of the jeep, that seems to be the wrong direction to me.