Search the Community
Showing results for tags 'conversion'.
-
So I picked up a 2004 XJ 4.0 engine and didn't realize the many differences in the block casting from the older 4.0. It wasn't until I started doing more research on the engine that I realized this, but I did get the engine for a really good price that was too good to pass up. Being that I've already put in some time into this engine, I HAVE to make it work. The first issue that I ran into was with the driver's side motor mount pads on the block. on the older 4.2 and 4.0 engine, the top bolt pad is pushed back about half an inch, and on the XJ 4.0 they are flush with each other. So, I we
- 17 replies
-
- jeep 4.0l
- engine swap
- (and 10 more)
-
I have an 04 Dakota 4.7 V8 4x4 with the 545RFE tranny. My plan is to swap in the 2.8 Cummins crate engine or possibly the 05 to 06 VM Motori 2.8 diesel out of the Liberty. Will the VM bolt up to my transmission? Does anyone make a bellhousing adaptor for the Cummins swap? thanks
- 9 replies
-
- 4.7 dakota
- 545rfe
- (and 9 more)
-
Hey I was looking to upgrade my 1998 Jeep Cherokee SE’s ignition system. My intent is to drop the distributor and replace it with a camshaft synchronizer (https://www.morris4x4center.com/dorman-camshaft-synchronizer-oil-pump-drive-includes-sensor-dor-689200.html?gclid=Cj0KCQjwn7j2BRDrARIsAHJkxmw1PJPPvcy8YpgleZmsRNOW_q9zw78_4IXXuvfIbh7uufSEW3rMaaEaAtSzEALw_wcB) , and a RIPP 3.8 High Performance Coil Pack (https://rippmods.com/collections/jeep-wrangler/products/ripp-3-8-high-performance-coil-pack). “Viper Coil Kit” Will this work with my current wiring harness and PCM? or will I h
- 1 reply
-
- jeep 4.0l
- distributor
-
(and 3 more)
Tagged with: