Search the Community
Showing results for tags 'Jeep CJ3B'.
Hello fellow jeepers, I'm new to the forum and wanted to share my current project. I have an old flat fender that's been in the family for around 30 years that was in dire need of restoration. It's turned into a ground up, the frame was twisted and severed in the middle and the tub was all rusted out. I completely rebuilt the frame, straightened it all out and reinforced the weak areas. I didn't box the frame as I want to retain some flex. I did some extensive panel replacing and patching on the tub and built new floor pans for the front and rear. The axles are stock D44 rear and a custom buil
Ok, got my subscriber membership now. So, after not doing much with the jeep the past couple winters due to my snowbike hobby I jumped back in yesterday. I have to reassemble the front axle and clean the rear axle housing. I ran into trouble with the new front wheel studs that came with my new wheel bearing hubs. There is a shoulder behind the knurled section that would not allow proper press-on fit. The jeep parts vendor sold me the wrong studs it appears. Napa was able to look up studs for a scout and I was able to look at one to confirm it will work. A second problem I found was my ne
In the postwar era, Willys pioneered the development and production of 4WD light trucks and the World's first "sport utility vehicles". If you like the WWII and postwar Willys and Kaiser era Jeep models, this forum provides a community of enthusiasts and restorers. Whether your interest is history, restoration, rebuilding, how-to, troubleshooting or sharing vintage Jeep 4WD experiences, you'll find support and build friendships here!—Moses Ludel At left is a Mopar flyer for Camp Jeep workshops by Moses Ludel. The red '55 CJ-5 was the project built and depicted within the book at right!