Search the Community
Showing results for tags 'amc 20'.
-
I feel like I am completely missing something here. I am attempting to replace the bearings on my 1985 Jeep CJ7 with AMC 20. As you'll see in the photo, I'm down to removing the inner race("B" in image). But I am looking at the axle shaft and tit has this flare("A" in image) sticking out which as far as I can see, there is no way I could possible get the new bearing over this flare out. All of the forums and tutorials say I should be able to slide the component down the shaft for pressing, but I just don't see how this would be possible. It seems to me I have to remove the axle shaft from
- 19 replies
-
- amc 20
- axle shaft
- (and 7 more)
-
Hi Im installing a new axleshaft and hub I've pressed the bearing on and slid the shaft in but the bearing doesn't seat flush is it supposed to be sticking out a 1/2 inch? I've slid the old one in and it's the same 1/2 inch sticking out does the brake plate suck it in place?
-
Hello Moses, Finally got the Rinky Dink jeep through the byzantine maze that is the Calif DMV, BAR Smog Referee and the CHP. Got the title completed and a new set of plates. 1st drive reveals mucho noise and vibration from the rear axle. Long story short, the axle should have .008" end play shows .250." Open the thing up and the carrier has .125" play. Not good. I questioned whether I wanted to tackle this as I have never built an axle. Talking with my son he said, Why not, If you can build a bevel Ducati engine (8 bevel gears) you can certainly build an axle. So, this is my questio