Search the Community
Showing results for tags 'Jeep 4WD'.
-
The axle shaft tapers have "teeth" that cut into the smooth surface of a new rear wheel hub casting. There is a minimum beginning axle shaft nut torque on Jeep CJs of 250 ft-lbs. For a new hub, this is followed by tightening the axle shaft nut further until you achieve the factory-specified stick-out length of the axle shaft threads (beyond the outer edge of the wheel hub). Note: I've attached the factory procedure in a PDF for those interested in the Model 20 AMC Jeep CJ axle shaft hub installation: AMC Model 20 Axle Hub Installation.pdf See your factory service manual, it will desc
-
I have an 82 cj with a dana 30 low pinion with 2:73 gears. I want to put 4:10 gears in it. Can I use a carrier and ring and pinion from a TJ wrangler or 2000-2001 XJ Cherokee mentioned in the dana 30 rebuild how to. I'm sure my pinion is long. I'm not sure if they are in the models mentioned above. Any help would be appreciated. Thanks, Mike
-
I am installing a front D44 front from a mid-70s Waggy in my 85 CJ-7. I have found some good write-ups on shortening the drivers side of the 44 to keep overall width the same. My current issue is that I want to convert the unit from the 6x5.5 Waggy pattern to the 5x5.5 CJ pattern. I have actually sourced a set of Ford outers, but am reading some things which concern me concerning later Waggy D44s maybe not being compatible because of some dimensional changes to the bearing. AS I am not sure of the year of the D44 I am now considering having a machine shop redrill some of the components on
- 21 replies
-
Disc brake conversions are popular, and I cover that topic in my Jeep CJ Rebuilder's Manuals (1946-71 and 1972-86 Editions, Bentley Publishers). Whether the CJ has a four-drum system or a disc front/drum rear system, the master cylinder must be considered during a disc brake conversion. There are two master cylinder concerns when converting to disc brakes: 1) the piston bore size and fluid volume per stroke of the pedal and 2) any "residual valves" that might have been used for the drum brakes. For disc brakes to work, the master cylinder must have enough fluid displacement to apply the