Jump to content

hobiecat

Members
  • Posts

    1
  • Joined

  • Last visited

  1. I have a 2006 Wrangler TJ 4.0 with 6 speed. About 6 to 8 weeks ago, I ran into a very troublesome electrical problem which I haven't been able to solve. However to try to fix it I put in my own ground system after taking some hints from other posts. here's what I did: Using all 4 gage cable I mounted a 3/8 in brass bolt on to the fender with brass nuts and washers after wire brushing (elec) both sides. This became my main ground point. I then made cables and ran my neg battery cable to this point followed by the tub, engine, frame , etc cables. I just had the cables crimped at an auto parts store. Each terminal was shrink wrapped. Once these were done I covered all bare metal and connection points with clear lacquer (borrowed from aircraft industry). The results: the jeep has NEVER run better and lights are brighter. However my original problem, no interior lights, no gages is still here. My radio, heater, cruise and exterior lights and directionals all good. So I have a decent ground system but need some help on this other stuff. Thanks, Hobiecat.
×
×
  • Create New...