Jump to content

Nate90wrangler

Members
  • Content count

    1
  • Joined

  • Last visited

About Nate90wrangler

  • Rank
    Member
  1. I hate to bring this up again, but I need help. I have a 1990 2.5 TBI wrangler that is killing me! I say I've been throwing parts at it, but given it's age everything I've done was either bad or well on its way. Now that almost everything has been replaced including the IAC I need help adjusting it. I assumed the IAC was in the correct position when I replaced it, but I'm suspect the PO had adjusted it when some of these parts I replaced went bad or possibly when they plated off the EGR (I replaced the egr and cleaned the egr tube) and now I find myself trying to adjust the IAC. I've adjusted it twice. The first time I was very close, but was not perfect so I adjusted it a turn more and it's acting up again. I've ready your very helpful advice, but call me slow I could use a bit more help or even pictures on how to do it the way you describe. The adjustments I made were before I found this page and I was told to just unplug it adjust it to 3500 rpm turn it off, plug it in, start it up for a minute then reset the ECU and I'd be good to go. Which is "close" to what I read here but miles away too. It did make it much better, but one more turn and it's back stalling out again. Can anyone give me pictures or better yet a video? I've hardly been able to drive the jeep since I purchased it.
×
UA-25687387-1